Low coefficient of friction; high surface load and pressure withstanding capacity
High and low-temperature performance
Protects surfaces from wear, galling and seizure
Oils, grease and solvent resistant
Prevents stick-slip and fretting corrosion
Provides clean dry film lubrication and does not accumulate dirt or abrasives
Offers surface protection from corrosion
Lubricates under adverse operating environments such as in vacuum or near radiation
Provides maintenance free permanent lubrication where oil or grease contamination cannot be tolerated
Excellent lubricity and highly abrasion resistant
Increases service life of equipment
Application
As a dry film lubricant for components exposed to abrasive or dusty environments as threaded connections, pins, levers, pivots, splines, bolts, chains.
As a metal pretreatment lubricant prior to assembly for effective running in to reduce wear, friction and eliminate metal to metal contact and seizure.
As a lubricant for components exposed to critical environmental conditions as vacuums, radiation, high temperatures, humidity.
As a heavy duty, high temperature thread compound to prevent seizure and corrosion and facilitate easy assembly and non-destructive disassembly.
As an anti friction coating for metal cutting tools as millers, reamers, taps, drills, gear cutters, punches, dies to prevent sticking, binding and metal build up; increase life of tools, production quality and efficiency.
As an extreme pressure lubricant for heavily loaded or stressed surfaces to prevent wear, friction, galling, scuffing, seizure and fretting as for press fits, pins, levers, pivots, bearings, gears, splines, journals, linkages.
Direction to Use
Shake the can vigorously for a couple of minutes before spraying till the bearing noise from inside the container is audible. Repeat before every application. Spray onto a clean, dry and degreased surface. Only a thin film of this lubricant is required. Allow solvents to evaporate. Spray from a distance of 20-30 cm. Repeat if necessary. Excess lubricant may fall off
during assembly. For cleaning the valve dip-tube after spraying, invert the can and depress the actuator button for a few short bursts till only the clear propellant comes out
