DOWSIL 3145 RTV Mil-A-46146 Adhesive / Sealant

One-part, moisture RTV, non-flow, high strength, UL and Mil Spec.

• Non-flowing
• Room temperature cure
• High tensile/tear strength and elongation
• MIL-A-46146 Group II, TY I
• No mixing required
• Room temperature cure, no ovens required
• Faster in-line processing with optional heat acceleration
• Can be considered for uses with Mil Spec requirements

Dow one-part moisture cure adhesives are generally cured at room temperature and in an environment of 30 to 80 percent relative humidity eliminating the need for curing ovens and the associated costs of energy and capital. Greater than 90 percent of full physical properties should be attained within 24 to 72 hours and varies according to product. Faster manufacturing throughput can be achieved since the adhesive and component can be handled in much shorter times of about 10 to 120 minutes, depending on the adhesive selected and the amount applied. These adhesives are not typically used in highly confined spaces or where a deep section cure is required as they generally cure from the exposed surface inward at a rate of 0.25 inch per seven days. Cure progresses from the outer exposed surface and is dependent on the moisture in the air. Working time is generally a few minutes to an hour for these products until a surface skin begins to form. Mild heat below 60°C (140°F) may be used to increase through-put by accelerating the cure. Dow adhesives retain their original physical and electrical properties over a broad range of operating conditions which enhance the reliability of and service life of electronic devices